Are you looking for:
|
Upper Strut Mount SET 4x (Fiat Bertone X1/9, Lancia Scorpion/Montecarlo Front and Rear All) - NEW
A SET of four high quality rubber strut top plates to fit the front and rear of all Fiat and Bertone X1/9 cars from 1973-88. Also applicable to the front and rear of all Lancia Scorpion / Montecarlo cars and Autobianchi A112.
4x pieces.
Manufactured exclusively for Midwest-Bayless, these are SHORE 90 durometer, stiffer than stock vulcanized rubber and will not deform or deflect over time like stock units or the "too soft" replacements offered elsewhere.
These usually compress, stretch, or degrade, enabling the car to attain an excess of negative camber, causing uneven tire wear, handling problems, or noise due to contact of upper strut hardware against the body.
Condition: NEW
New and unused.
|
Door Handle Lock Tumblers w/Matching Keys (Fiat Bertone X1/9, Ferrari 308, Lancia Stratos, Lamborghini) - OE NOS
This is a Pair of F/I/A/T Factory OE door handle lock tumblers by Cromodora with matching keys for all Fiat and Bertone X1/9, Ferrari 308 GT4, Lancia Stratos and Lamborghini cars.
Condition: OE NOS
Original Equipment New Old Stock
New and unused.
|
Axle Hub CV Spindle Stake Nut M24x1.50 (36mm Hex) - Front / Rear (Lancia Beta Coupe, Zagato, HPE, Sedan All) - NEW
A CV-joint / axle / hub nut for all Lancia Beta cars. Also applicable to other Lancia and Fiat versions
36mm hex M24x1.5 with stake flange, applicable to front.
Condition: NEW
New and unused.
|
Fender Rear Left Quarter Panel - Repair Patch Panel - Forward Portion (Fiat Pininfarina 124 Spider All) - NEW
This is a patch panel for the left rear (NA-spec driver side) fender on all Fiat Pinifarina 124 Spider cars.
Fits between rear wheel fender arch and door. Also known as "rear rocker" area.
Heavy gauge steel with correct fender arch contour. 12" tall.
Condition: NEW
New and unused.
|
Intake Manifold Vacuum Fitting - 14mm Auxiliary Air (Fiat Pininfarina 124 Spider, 131 1980-On w/FI) - OE / RENEWED
A Factory OE manifold vacuum fitting for Fiat and Pininfarina 124 Spider and 131 cars with FI. Used on the end of the intake plenum for the auxiliary air valve hose.
14mm
Condition: OE / RENEWED
Either Original Equipment New Old Stock as supplies permit, or clean used unit that has been stripped and replated like new in yellow zinc.
|