Are you looking for:
|
Fuel Injector SET 4x (Fiat Pininfarina 124, 131/Brava, Lancia Beta + X1/9) - OE BOSCH NOS
A set of four F/I/A/T Factory OE Bosch Germany made fuel injectors as fitted to injected Fiat Pininfarina 124 Spider, Fiat 131/Brava, and Lancia Beta cars, including Coupe, Zagato and HPE.
Bosch PN 280 150 121.
Original Bosch injector rated at 145cc / minute flow.
Manufactured with exact hose length pre-installed, ready to fit to the fuel rail.
Exact same injector as used on X1/9, just shorten the hose.
Application(s):
Fiat Pininfarina 124 Spider F.I. (1980-85)
Fiat 131 / Brava F.I. (1980-82)
Lancia F.I. Zagato, Coupe , HPE (1980-82)
Fiat Bertone X1/9 (1980-88)
Condition: OE NOS
Original equipment New Old Stock.
New and unused.
|
Heater Control Lever Cable - 42" CUT TO FIT REPLACEMENT (Fiat X1/9 All, 128, 124, 131, Lancia) - NEW
A replacement heater control cable for Fiat and Lancia applications, including Fiat 128, X19, 131 and others..
Inner cable is 45 inches OAL, with loop on one end.
Outer sheath is 42 inches OAL.
Cut to length and shape end(s) as needed to match your existing cable.
Condition: NEW
New and unused.
|
Flywheel DOHC w/10mm Bolts - 200mm (Fiat 124 Spider, Coupe - 1438cc Style - 1967-71) - RECONDITIONED
A flywheel as applied to 1967-71 Fiat 124 Series cars with 1438cc engine.
Uses 10mm flywheel bolts and 35mm pilot bearing.
200mm diameter and friction surface, smaller than later flywheels.
Condition: RECONDITIONED
A clean used flywheel that has been media stripped and resurfaced with proper step height. Good ring gear. Ready for install.
|
Fuse Block Box - 10 Fuse + Cover (Fiat 124 Spider 1968-77, 124 Sedan, 850, 128) - OE / RECONDITIONED
This is a Factory OE fuse block assembly with cover. Part number calls out to 1975 Fiat 124 Spider cars but works for all Fiat 124 Spider 1968-77 with 10-fuse panel.
Condition: OE / RECONDITIONED
Units have had terminals cleaned and removed of tarnish and oxidation. Like new.
|
Cylinder Head Manifold Hardware Stud Set SOHC (Fiat Bertone X1/9, 128, Strada/Ritmo, Yugo All) - NEW
A set of seven threaded studs with hardened thick washers and copper locking nuts for the cylinder head manifold flange of all Fiat SOHC engines as found in Fiat X1/9, 128, Strada, Yugo.
All stud measurements below are "above the surface"
2x - M8x30 Stud
2x - M8x40 Stud
2x - M8x50 Stud
1x - M8x55 Stud
7x - M8 Hardened Thick Washers
7x - M8 Copper Lock Nuts
Condition: NEW
New and unused
|